Jump to content

Leather valves cut short


Recommended Posts

I have a 1928 octagonal Wheatstone Baritone/Treble English concertina needing some work on its leather valves. The highest 5 or 6 of notes have both their valves cut short exposing some of the opening.

 

I believe this is original.  Was it done to avoid excess pressure on such tiny "brass" reeds with those large bellows?

 

All the Best

Nigel

Link to comment
Share on other sites

Nigel

I am not an expert but I have done some repairs on a few vintage Anglos.  In each case there were no valves at all on the very highest reeds and it looked as though they were made that way.  I am sure some more knowledgeable members will chip in and explain why.

John

Link to comment
Share on other sites

In some cases when this is not done the high reeds won't sound at all, its because the air pressure just causes them to choke too easily - as due to the size of the reed its set very low comparatively to the lower pitched reeds. If you partially cover the slot it allows some of the air pressure to escape through that slot (passing through the reed on the other side without causing a sound) and the reed wont choke. On some instruments you see the chamois gasket removed from the high reed chamber end partition - if I remember this is done for the same reason. 

 

Its just one of the old tricks of the trade people used to employ - it works though.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...